Can You Use Foil Tape To Repair A Leak In A Drain Pipe
1) Preparation
Reduce line pressure to 60 psi (4 bar). Roughen piping surface using a wire brush or sand newspaper to remove excess rust, clay or loose scale. Remove whatsoever oils, greases, soaps or foreign materials from pipe surface.
Unroll showtime 6" from roll of black rubber Pressure level Sealing Tape and remove backing; set bated.
two) Put on Latex Gloves
Warning: Gloves must be worn at all times.
Complete Step 3 or 4, depending on your awarding. Then proceed to step 5.
3) Pinhole
Remove Syntho-Steel™ putty from packaging and knead putty until uniform in grey color. Identify a ball of mixed putty just big plenty to fill up the void above the pinhole.
four) Joint/Potable H2o System
Remove Syntho-Steel™ putty from packaging and knead putty until uniform in grey color. Mold mixed putty into a one/8" - ane/4" (3mm - 6mm) rope & place around entire circumference of the joint, pressing firmly into place. Note: the rope should not exceed the shoulder of female fitting.
Optional: For difficult repairs, apply PHP strip in lieu of, or in improver to, putty (Stride 3 & four). Remove adhesive backing from PHP strip and use in an overlapping manner around the entire circumference of the joint.
five) Apply Black Safe Pressure Sealing Tape
Printing agglutinative side of tape onto piping abreast Putty or PHP Strip and overwrap 2 layers of tape onto itself in a clockwise management, thus anchoring the tape to the piping. Continue wrapping tape, stretching information technology to its maximum tension, working toward putty, thus pushing the putty into the defect. Wrap the remainder of tape direct over the putty, forcing the putty into the defect. Do not chase the leak, equally each wrap of tape provides boosted pressure to seal the leak. Use unabridged roll.
End: After applying tape, test repair by following your leak detection process to ensure the leak is sealed & contained. If leak persists, remove tape and putty and repeat steps.
6) Soak PERMA-WRAP™ and Wrap Pipe
Open foil pouch containing PERMA-WRAP™. Immediately pour h2o into the foil pouch. To ensure water reaches all areas of record, squeeze wrap while submerged in h2o. Submerge wrap for 15 seconds.
seven) Wearing Latex Gloves
Remove wrap from pouch and tightly wrap, keeping tension at all times. Continue wrapping until you attain 8-10 layers of PERMA-WRAP™ extending ii inches on both sides of the leak with l% overlap. Occasionally twisting wrap as it is applied helps it adapt tightly to the pipage surface at elbows or odd geometries.
8) Remove Backlog Water
In one case wrap is applied, clasp and mold in the direction of the wrap to remove backlog h2o, spreading resin until tacky to touch and ensuring the layers of wrap will tighten.
9) Allow Cure Time
Allow thirty minutes for cure time at room temperature (75F) before resuming pressure to the line. Cooler temps or high moisture conditions will extend cure time.
Leak Repair Instructional Video
Leak Repair Demo Video
Can You Use Foil Tape To Repair A Leak In A Drain Pipe,
Source: https://www.permawrap.com/howtouse
Posted by: oliphantsperoar.blogspot.com
0 Response to "Can You Use Foil Tape To Repair A Leak In A Drain Pipe"
Post a Comment